Diesel Jeep Forum banner
1 - 3 of 3 Posts

· Registered
50 Posts
Discussion Starter · #1 ·
When I bought my diesel GC the block heater cable wasn't installed but the dealer said the heater was there. So I finally purchased the cable (after another dealer said they were not available), but now I can't find the plug on the heater end. I've searched all the threads and there are good photos showing access via the psgr wheel well, but my GC has the quadra lift air suspension and skid plates (often I work off road) so there is a lot of metal blocking the access via the wheel well. Tried looking from above and below but no luck. Anyone know of a tsb or has done the install? Tried my local dealer. They couldn't find it either.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.