2017 WK2 Summit 3.0 V6 Diesel
The coloured guidelines when reverse is selected no longer show.
I have reset the U-connect module but still nothing.
Going into the options, the item is checked - if I uncheck it, it just re-checks itself after a couple of seconds.
Have also tried reset to factory settings which showed the SRT logo when it started up which I thought was strange.
Any tips on how to resolve ?
I haven't seen this problem reported before. The only possibility I can think of is that there is an input missing - steering angle perhaps - that is causing the system to turn itself off. How you can figure that out I have no idea, unfortunately.
You might consider joining Jeep Garage - Jeep Forum to see if there is more information over there. It is a much larger forum and covers all models of Jeep, so it is more likely that someone has seen this before.
A forum community dedicated to diesel powered Jeep owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!